CEN MG10 spur Gear
Description
I design the spur gear for old car cen mg10 to repair it at low cost. I tested to print it flat in pla 0,2 mm 3 walls and 70% infill and activated support it work for now ... made 4 run without break... next time will print it on better stronger filament but design is ok for PLA. Just need to make small rework on disc support to perfectly fitt the disc... i give you the SKP if you need to change fews tolerance for main hole or disc support . the current stl fit perfect on my prusa...
Statistics
Likes
2
Downloads
0