CR-10 Bed Clip for 12" glass
Description
Liked the original design, but didn't fit my 12" glass bed and interfered with the Z-axis, so remixed the clips to be small and thinner. Update: Found that the clips didn't hold the bed well enough and would eventually slip off causing a failed print. So I made an anchored design that also acts as protection against the spring digging into the heated bed. Depending on your tolerances, you may still need 1 alligator clip to keep the bed totally solid, however, now it has no chance of sliding off. This clip should be printed on its side and does not require any support. I recommend using 3 of the anchored bed clips and the 1 Strain Relief Corner clip.
Statistics
Likes
23
Downloads
0