Auto bed level strain gage for HyperCube 3D printer using resistors 2512 instead of strain gauges.
Description
This project is based on a change in the resistance of resistors under the influence of external factors in particular deformation. The object of the project is to check whether it is possible to use ordinary smd resistors instead of strain gages, and apply this effect to the calibration of the bed 3d printer. The sensor was developed for a HyperCube 3d printer by Tech2C https://www.thingiverse.com/thing:1752766. You can find out more about the project at:https://github.com/IvDm/Z-probe-on-smd-resistors-2512
Statistics
Likes
6
Downloads
0