Valkyrie187 V-Tail Mini-Quad
Description
5" version of the Valkyrie. Top plate and camera mounts are the same as for the 137. I will be doing variations of the camera mounts for other camera sizes, and uploading them. Make sure you place the arms flat on the bed before preparing to print. Also remove any auto-generated supports in the arm tubes. The antenna tubes are impossible to clean out, and the motor wire tubes are a pain. it prints those fine without supports. Included is the .gcode for all components in PLA at 33% infill (17hr 45min print! Maybe better to print one at a time). Also ABS at 80% infill. Will fit up to 23XX motor.
Statistics
Likes
35
Downloads
0