200GT LDARC top plate and CP antenna holder
Description
So this is a design I made in tinkercad to replace the top mount of the ldarc 200gt. I don't like how crammed everything was in there and i needed more room! I haven't printed to top plate yet but i'm sure nylon would be the best! The antenna holders i printed using tpu and just removed one of the standoffs in the middle and replaced it with this. it should just screw right in and hold. Would probably use some hot glue or someway of securing the screws a little better in my opinion. The Antenna i use: https://www.banggood.com/Realacc-UXII-Stubby-RHCP-U_FLIPEX-IPX-5_8GHz-1_6dBi-Super-Mini-Antenna-For-TX-RX-Fatshark-Goggles-R-p-1256043.html?rmmds=myorder
Statistics
Likes
4
Downloads
0