Digiscope Adaptor Mk1 for Canon EF
Description
This adapter allows you to connect your Canon EF mount DSLR to a Spotting scope - this specifically designed for My Nikon Fieldscope - (or any other with a 36mm or smaller Eyepiece) noticed there wasn't really anything i could just print and go. so had to modify my own (from https://www.thingiverse.com/thing:2509619 - thanks Canyonazo) - there are many digiscope kits available online to purchase that do the exact same thing, but with this the cost is basically 9 meters of filament and 2 hours printing time on my cheap i3 Clone Canon EF mount *EDIT* - i have created some small shoes/shims that the screws can tighten down on inside the adapter and it had made the whole assembly far more secure, and much less likely to damage the eyepiece - also printed with my New Prusa MK3, and found i needed to print at 101% scale to allow a better fit to the camera. 3x M3x15mm screws to adjust and tighten to eyepiece but if you have a very steady hand, you might not need it. i used it with Canon 4000d and remote shutter. No Support for printing needed at a 0.2mm and 0.15mm layer height in PLA Can easily be modified to fit other scopes if you have some software and measurements *Remixed from T-Ring adapter for Canon (1.25" and 2" ) for telescope by Canyonazo*
Statistics
Likes
7
Downloads
0