ball bearing dual extrusion
Description
this was a project that took me 3 weeks to make, it was tested on a QIDI X-PRO and i am 1000% sure it will work on most printers. Just follow the print stettings and it should work, NOT FOR ABS. P.S. The build plate was: 45 Degrees Cellulose, And the extruder was: 210 Degrees Cellulose. And: the base that the balls sit on is going to be two colors (every other lair is going to be a different color on the base for the balls), For instance if you had red and green it would go red green red green... (If your primary color is red). When the print is done you may want to pop the balls loose with a screwdriver (Works better with a smaller screwdriver, And pop the base off (Base that the balls sit on) with a screwdriver as well. And when you do that you may want to play with it for a while to make it faster (So it will actually spin freely).
Statistics
Likes
2
Downloads
0