KB3D Makercoin! print in place!
Description
I wanted to make a nice coin for a while now just like a print in place design, so i came up with a combination of both. I uploaded 2 files one 0.25mm and one with 0.3mm gaps. The blue one on the picture is the 0.25 gap 0.15 layer height, I had to brake it free a little on the bottom and the outer ring didn't turn as smooth as intended but i printed it pretty fast. The red one is the 0.3 gap 0.1 layer height, popped of free as can be but that went on normal speeds. 0.3 should be possible in 0.2-0.25 layer height but haven't tried it yet. If you make one please share a make! Like share follow and enjoy!
Statistics
Likes
11
Downloads
0