Tevo Tornado X-Axis Tensioner
Description
I noticed that my Tevo Tornado could not properly attach or align any of the CR-10 or CR-10S X-Axis tensioners. The Tornado X-Belt alignment seems to be lower and towards the rear, than dead center of the 2020 extrusion. Keeping that in mind, I found this X-Tensioner and remixed it to fit the Tornado accordingly. So far, it's holding up excellent with good tension and no belt scraping on the tensioner. Only the bracket (ATRM_Bracket_v211) was remixed to fit. All other parts are unchanged. Props to the original designer of this tensioner. For more details on hardware, screws or any other information, refer to the original design. Check notes below for print recommendations.
Statistics
Likes
130
Downloads
0