Adjustable Smartphone Stand / Tablet Stand

Description

This is simple adjustable smartphone and tablet stand. You can easily and quickly change the angle. There is a rubber band inside. ---------- Update(2020/8/23): In the current condition of my printer, gear part was too tight. So, I made the gap slightly larger. Only Male was modified and it became v3.2. The diameter of cylindrical part of V32b is 0.1mm smaller than that of V32a. V32a-Male.stl and V32b-Male.stl are only for checking gaps. Please print SmartPhone(Wide)StandV31-Female.stl, V32a-Male.stl and V32b-Male.stl first to find good combination, then print SmartPhone(Wide)StandV32?-Male.stl. If the cap is too tight, please shrink only x and y of cap slightly. This is remix of https://www.thingiverse.com/thing:3048358 To increase the rigidity, the legs became thicker. And I made a movie file for assembly. https://youtu.be/WAh2LkIBGTM ---------- Update(2020/5/3): I made thinner models for Male of V31. Also, small test models were made. ---------- Update(2019/8/26): Resolution of V4 models were improved. Thank you for comment from Nicolinux! ---------- Update(2018/11/11): Thanks to Saur0n, wider version was modified (V4). If you use silicon/rubber pads, it becomes more stable. You can use same cap for this, too. ---------- Update(2018/10/31): Based on the comments of Saur0n, wider version(+2cm) was added. (Thank you, Saur0n!) Although I did not use support with my printer, I modified the model by using chamfer instead of fillet. I hope the printing becomes easy even without using support. ----------

Statistics

Category

Tags