MakerBot replicator2 button - pla / abs (no need for fancy flex material)
Description
Get an old tv remote . dissect it to get the buttons ( made of silicone and on the opposite side there is a small black material that can conduct electricity ) Cut 5 of these buttons black round pieces. ( need a sharp utility knife ) After printing - use "super glue" (with latex gloves) to connect the tiny black conductive rubber to this button's back side - the are special grooves for the glue. Be careful - not to cover the conductive side with glue as it may not conduct. Enjoy :) *print with breakable supports . with a raft .
Statistics
Likes
4
Downloads
0