Xinkebot ORCA 2 Cygnus X-Tensioner
Description
X-Axis was too slack and belt springs wouldn't cut enough of the tension so I made this tensioner. It fits fairly snug on the extrusion, I have .2mm clearance on each side. BOM: Existing bearings 2- M5x30mm hex head bolts - Could get away with 25mm and one less nut 3- M5 nuts 1 X-Tensioner.stl Optional: X-Tensioner Handle.stl 1- M5 nut - secures the handle to the bolt Printed without any support - the first layer after the nut slot had a little bit of stringing on the hole, but the bolt pushed it out of the way.
Statistics
Likes
7
Downloads
0