Desk stand for Lutron Caseta Pico remote
Description
I decided to adapt my [Lutron Pico wall plate bracket][1] into a desk stand. This uses the mounting slot on the back of the Pico remote, so it's easy to attach and remove. **New Version:** I am adding a new version of the stand which I like better. The body prints in one piece, and I've included supports which work better than what most slicers will produce. The feet are separate parts and have compartments for M5 nuts to give them some weight. Glue the feet into the base and you're done! **Old Version:** The two pieces of the stand use a dovetail joint to simply slide together. There's plenty of clearance in the joint to allow you to grab the top portion and use it as a hand-held remote, then drop it onto the base when you're done. The base is designed to print without supports; there's no overhang more than 45 degrees. The top portion may need support under the dovetail slot, as there's a bridge of roughly 2cm. [1]: https://www.thingiverse.com/thing:3111857
Statistics
Likes
25
Downloads
0