Heated-Glass Bed Clip
Description
###UPDATE: 2/31 In the process of updating the design slightly. The glass plate, that was tight, has loosened slightly over time. I am tightening the pressure on the glass plate by increasing the depth the clip overhangs the bed, and also adding a chamfer to prevent the clip from hanging on a buid mat. I have added the stl for the new design but I have not finished testing. Will update when complete. ----- These were designed to replace the clips I used to hold the heated glass bed in place on my Hypercube Evolution. If the binder clips were not positioned exactly correct they would catch the hot end during bed leveling; and, the clip pressure deformed the glass on the bed. These clips press against the edges of the glass to hold it in place. They do not hold the glass down so it can be lifted from the bed without removing them. They are designed specifically for my bed measurements but may fit others. - Heated bed - 308mm square and 3mm thick - Glass - 298mm square - Cork Insulation is 3mm thick - Leveling screw hole centers are positioned 3mm from corner edges
Statistics
Likes
8
Downloads
0