[idbox] DIY Hotend Heat-Sink/Spreader

Description

This is an integrated heat sink and heat spreader for DeAgostini idbox. This heat sink/spreader reduces heat creep during PLA printing. ##Requirements - Copper wire - Diameter: 0.3mm-0.4mm - Thermal paste/grease - Silicone based thermal grease - Other pastes Read the safety data sheet for use it. - Anti-seize copper paste - Boron nitride paste - Carbon/Graphite paste - Unfluxed copper desoldering wick/braid - Width: 3mm-4mm - Spiral wire wrap - Inner diameter: 5mm - Outer diameter: 7mm - 2-3 x Twist ties ##Related Link - [idbox LEAD NUT CASE by ichibey](https://www.thingiverse.com/thing:2142060) - Hex nut for comparison was taken from here

Statistics

Category

Tags