Guitar Radius Block 9,5 inches
Description
I remade this guitar fretboard radius block because the original model was way too wide. The radius is 9,5" (like on a modern strat). I included a version with only the bottom radius part so you can stick it to a piece of wood. This will save you a lot of print time and material. You can print the tool at any length by adjusting the Z height (print the model with the short side facing down, of course). And you can sand down the curved part a little once the print is done to get a flatter surface. And remember to check your material shrinkage rates (usually between 0,5 to 2% depending on the filament type and brand) to get an accurate object and adjust X and Y accordingly. This will be a tall print so consider using double sided tape on your bed or maybe a raft if you have adhesion problems. Thanks to the original uploader!
Statistics
Likes
10
Downloads
0