E3D Titan Mount for P3 Steel Toolson
Description
Extruder Mount for the p3Steel Toolson Edition Needed Parts: E3D V6 direct E3D Titan Noctua NF-A4x10 FLX (or the Original E3D Fan) 40mm Fan Grill 5015 Fan optional: BLTouch Screws: a set of M3 Screws of different length would be usefull + washers + nuts 4 M4 Screws for the Noctua Fan 4 M4 nuts for attaching to the p3steel Toolson x carriage Attention: carefull when installing the bltouch! its mounted to high and must be installed with washers!!! (5 each side in my case) Was a failure, but after installing with washers i liked using the hole for the cable. The Offset for the BL-Touch is (not 100% exactly): x -32 y1 z -2,8 (just in may case!!!)
Statistics
Likes
17
Downloads
0