Groovemount Bowden Connector
Description
Tired of having your bowden setup failing in the middle of your print because the hose keeps popping off? I was, so I made this groovemount fitting with M6 threading on the inside. Just screw in a PC4-M6 connector and you now have a locked tight bowden set up! 1. Print Part 2. Install PC4-M6 Connector (Usually takes a wrench, it's a purposefully tight fit) 3. in the back, push in a bowden tube as far as you can, and then cut it flush with the back of the part. If you'd like the original file, or just want another thread type available to print, leave a comment below and I'll make it available to download! Below is the amazon link to the PC4-M6 connector you'll need for this project... https://www.amazon.com/Eowpower-Pneumatic-Straight-Fitting-Connector/dp/B01MQYJ9T6/ref=sr_1_3?ie=UTF8&qid=1540988589&sr=8-3&keywords=pc4-M6
Statistics
Likes
23
Downloads
0