Mickey Pumpkin Main St. USA Tealight
Description
UPDATE(2018/11/04): See below. Went looking for this or something like it and it couldn't be found. So I made it myself. Started with a nice uniform pumpkin source. The final design isn't perfect, but it's good enough. Might have to make a diffuser for the tea light to make it look it's best. A bit late in the season, but better late than never. Make sure to print two of the top_small models, one for each ear pumpkin. Designed for 36mm tea lights (Ashland from Micheals). Re-cut the hole at the bottom to fit your lights. Might want to glue the tops on after cleaning out all of the supports. UPDATE(2018/11/04): Added Diffuser model. See picture. This is for stacking\gluing onto the tea light to help it's light reach the full pumpkin height/ears and to block the view through the faces to the other side. Printed using Spiralize mode so it is only 1 layer thick and it's suggested to use a clear PLA if you've got it, but even matching orange PLA might work well as well. LIT pictures are using Diffuser.
Statistics
Likes
112
Downloads
0