Necklace holder
Description
This is a necklace holder where you can rest your jewelry. Total height is about 30 cm and it's in 3 pieces. I did three print's until I was happy. Tolerances aren't always easy but I'm more of a "the tighter fit the better"- kind of guy. I ended up printing this in low quality (0,3 mm layer height) and had to spend a minute or two sanding to get a nice snug fit. Printing in higher resolution should provide a perfect fit. Other than designing necklace holders I occasionally read a book, there is one book that is about me, you can find it here: https://www.amazon.com/dp/B079BT3RG6 Happy printing!
Statistics
Likes
61
Downloads
0