Anet E10 Ultimate Carriage (by ashdinalt) with standard wheels
Description
I printed asdinalt's Anet E10 ultimate carriage https://www.thingiverse.com/thing:2846338 and tried to use it with the standard wheels. However the bottom part had to be sanded down quite a bit to fit at all. And due to the smaller wheels the x-belt paralizer were about 2mm too low. So here are the Parts to fix these problems and use it with the standard wheels. I also included some spacers for the wheels, because on my printer they were in bad shape (especially the one for the bottom wheel). And a version of the fan duct for a single fan. Just in case. For the rest of the parts please see the original Thing: https://www.thingiverse.com/thing:2846338 If you're having trouble finding longer M2 screws for your X end stop switch, or the switch is now in the wrong position, you can try this: https://www.thingiverse.com/thing:2665582
Statistics
Likes
13
Downloads
0