False ceiling 3 inch pole cap
Description
If you want to see what else I am making, follow my instagram! @wiseprints206 Essentially this is designed to snap around a 3 inch support beam that goes through a false ceiling. The false ceiling in this case was crumbling where the beam entered, and a cap that fit on the beam was needed to cover the mess. This design should fix the issue. I designed them with inches not millimeters, so when they get put on the build plate, its going to be 6 mm long end to end, rather than 6 inches end to end. just scale it up to inches by sizing it up 2540 percent. Side note: it made me select lulzbot mini 2 on the printer list before I could publish, I did not print this on a mini 2 and dont know if it will fit on the bed or not.
Statistics
Likes
0
Downloads
0