ANET A8 Rear Bed Level Sensor Holder
Description
The original support by TNS hits the frame of my Anet A8, so I edited it removing a small part on the right side to prevent collision. These are the parameters I set in Marlin configuration: `#define X_PROBE_OFFSET_FROM_EXTRUDER 27` `#define Y_PROBE_OFFSET_FROM_EXTRUDER 57` `#define Z_PROBE_OFFSET_FROM_EXTRUDER 0` And, optionally, to be universally usable: `#define FRONT_PROBE_BED_POSITION (Y_MIN_POS + Y_PROBE_OFFSET_FROM_EXTRUDER + 1)`
Statistics
Likes
4
Downloads
0