Bicopter Tilt Mechanism for 13 mm Servo with 10% Dihedral
Description
For use with RCExplorer Bicopter: https://rcexplorer.se/shop/ Servo Holder for use with BMS-385DMAX. (13 mm wide) If printed from Nylon, "Servo-Holder" should weight about 2 Grams while the "support" mount should weigh about 6 Grams. Motor Holder can be found here: https://www.thingiverse.com/thing:3099720/files Main hole is for 9.5 x 9.5 mm Carbon rod with zip-ties used to secure the entire assembly. Granted, David's shops says these rods are 10 x 10 mm but my measurements show differently. Guessing there is some variance in the rod dimensions so some filling out of the hole may be necessary to achieve the correct fit.
Statistics
Likes
8
Downloads
0