3D Systems Cube 3 Cartridge Quick-Fit Bowden Tube Bulkhead
Description
I feel totally negligent about not posting this up earlier. This little widget was dropped in favor of a hub system that did not require the stock 3D Systems Cube 3 cartridges. However, for those of you just wanting to get the printer going, you might be able to make use of this. Please note that the print has a small "cooling tower" included to help make sure the threads form properly. I do suggest drilling the through hole to a #34 drill, or something near .111" [2.8mm] diameter. If you get the fitting started right, it will tighten up nicely. I also suggest chasing the M5 thread included in the print. Note the grind on the M5 bolt threads in the "drill-bit" image. Also note that you need to remove the built-in break-away supports.
Statistics
Likes
15
Downloads
0