CR10 BALL BEARINGS SPOOL HOLDER
Description
CR10 SPOOL HOLDER UPDATE 27 11 2018 Light as a feather! 2 23 NOV 2018 New parts - Shaft Reduced 5, Bolt, Washer, Cup and Ax 35.8/Ax 35.6 bearing housing Two versions of the Bearing Housing - AX 35.6 and AX 35.8. (inside diameter) Based on your experience, with your printer, choose the best one for you! 23 NOV 2018 Bearings fit good on position - press fit - maybe a 0.15 or 0.2 is much better - for Main Shaft only. A design mistake, need to change the "securing" on position of the Main shaft with something stronger than the PLUG! I secure my unit with a self thread screw! :) UPDATE coming soon. SHAFT - print was too good - if I can say - the offset was 0.3mm - therefore 0.6 for the diameter of the shaft. However, the ball bearing is too lose... I modify the shaft with 0.05 offset to have a tolerance off 0.1mm between shaft and bearing. Same goes for AX - new version AX_35.1 Design to use the CR 10 original metal bracket. Use two Ball Bearings ( :) ) 6202 - 15X35X11 or use the bush/bearing print part. See Filament Press UPGRADE! https://www.thingiverse.com/thing:3227058 DESIGN TO PRINT WITHOUT SUPPORT! :) By COSTA
Statistics
Likes
9
Downloads
0