Superman Dual extruder Tri-colour trick
Description
Misc Notes Merge dual colour model in your slicer by selecting them both and clicking "merge" after selecting a different extruder for each model. 3 Colours from 2: This is one single print with 3 colours from a dual extruder, by using a hot swapping method. No need to pause print. When the blue is finished printing and it starts to print red (about half way up), turn your print speed right down while you pull out the blue filament and put yellow in. I screwed this up by pulling it out a little early while it was still extruding blue, but it didn't matter on the infill and still came out fine. You need a large purge block as the yellow and red and blue are strong colour changes. I have added the Gcode from Cura 3.5 to replicate exactly as in the picture. I ended up turning the speed down to 80% during printing as my jerk settings were a little high.
Statistics
Likes
22
Downloads
0