HICTOP 3DP-17 ATHORBOT A01 i3 Z Axis Leveller
Description
Hej fellow Makers! This is my design of yet another z-axis leveller for a HICTOP 3DP-11/13/17 / ATHORBOT A01 Prusa i3-clone (it's identical) built with a single 20x20 ITEM frame. Just print two pieces, put them between frame and z-rods and screw the leadscrews to the upper surface of the levellers. The bottom side without the smaller wall goes over the rear motor bracket screw towards the z frame. Enjoy! If you have an improvement proposal please leave a comment. Unfortunately necessary: No liability for damage to your device! Print and use at your own risk.
Statistics
Likes
5
Downloads
0