Anycubic Kossel V6 parts-cooler
Description
A parts cooler for the stock Anycubic Kossel that allows usage of the stock probe. Install in the following way; - install V6 with the "long" side of the heater block to the side where you used to attach the magnet probe. - install magnet for probe over the hole for the parts blower - install this with a 5015 blower fan. There is one small m2 screw that holds it snug to the stock effector plate. You can access this screw from the hole in the top. There is a little pressure-fit cap that keeps the air inside the chamber after the screw has been tightened. This is work in progress, but works well-enough in its current form. next version will guide the air better.
Statistics
Likes
4
Downloads
0