Simple Phone and Tablet Stand
Description
This is a simple stand intended to hold either a small tablet or a phone in the landscape orientation. It uses two 8 mm steel rods to connect the two halves together. I wanted something that was simple to print and didn't require any supports and also wanted to get rid of some spare parts I had laying around. The photos show both an iPhone 8s and a Samsung Tab A 8". The supports are close enough together that you can put a tablet in portrait mode. Steel rods were used because I had them laying around and liked the way they looked. You could just as easily print some shafts but if you are not going to use steel rods, there are many better looking stands on Thingiverse. I think it would look nicer in white and can be printed from any material... I had black PETG loaded up so that's what got printed. The 8mm rods that I used can be found on Amazon: http://a.co/d/58FrYdv
Statistics
Likes
19
Downloads
0