Wanhao D6 / Monoprice Ultimate Maker Spool Holder

Wanhao D6 / Monoprice Ultimate Maker Spool Holder

Description

This is a remix of TERRAoperative's ALREADY AWESOME Spool holder located here... https://www.thingiverse.com/thing:2526942. I found that his cones were too small for some of the filament spools I was using so this set is meant to increase the capability. They work exactly the same as his original design only for larger spool holes as well as the smaller ones. I also changed the grip he created for the end of his spool as mine kept breaking off. I went with a grip cylinder rather than the two tabs. Otherwise completely his design. This has been tested with his suggested hardware for and with 5/16 inch hardware for those us in the US. Parts list is below and his assembly video holds up with this version too: 2x 608 bearings (Fidget Spinner or Skate Board Bearings, standard size) 2x M8 or 5/16 nuts 1x M8 or 5/16 nylon lock nut 3x M8 or 5/16 washers 1x M8 or 5/16 spring/lock washer 1x M8 or 5/16 threaded rod, 150mm long (5.5-6 inches)

Statistics

Likes

9

Downloads

0