Parrot AR Drone 2.0 Foot Extension
Description
Update: Created a new version of these feet because they snapped while performing a controlled (hard) crash from about 40 feet in the air. Reinforced the "clip on" part of the foot with a rounded back to prevent breakage. Also added a small round section to connect to a foot with a spring in it to absorb more impact (not yet tested). If you choose to test the prototype spring foot, you need a very small spring to insert into the carrier then push and snap it onto the main foot. Make sure when printing the drone foot that you lay it flat on the side without the rounding. You can find the flat side by zooming in on the model in your slicing program... These extension feet work great to keep the drone above the leaves and tall grass. Print 4 of them and they slide over the existing feet and hold firmly. They even have little slots for small zip-ties to fit through if you want a "shock absorbing" foot.
Statistics
Likes
12
Downloads
0