Slim spool holder for original prusa mk3 double spool holder
Description
I've a lot of filament with narrow opening for spool holder. So I've removed original spool holder part from the one side and mounted mine slim version. What would you need: * Some M6 threaded bar * Some bushing with 6mm hole inside, length should be 1cm-1.5 cm shorter then ro , from both sides. Make: 1. Clean key (teeth) on the top of printed part named _key_. There could be some hanging filament, when printed unsupported. 2. Screw one side of the rod into the _key_ 3. Slide bushing (pipe) on the rod. 4. Screw _nut_ on the other side. 5. Mount on Spool holder same way as instructed in [Prusa's MK3 manual](https://manual.prusa3d.com/Guide/8.+Electronics+assembly+(B7-R3+design)/823?lang=en#s14151). Usage: 1. Unscrew the _nut_ 2. Load new spool 3. Screw the _nut_ back
Statistics
Likes
1
Downloads
0