Pear Effector for Kossel Plus - no ABL
Description
This is the final version for my "pear effector" for Anycubic Kossel Plus. This version doesn't use ABL (Auto Bed Leveling, with this sensor: https://images-na.ssl-images-amazon.com/images/I/610KiapPaZL._SY355_.jpg) neither Zesty Nimble, look for other version here: https://www.thingiverse.com/thing:3255033 (with ABL, no Zesty Nimble) and https://www.thingiverse.com/thing:3255093 (with ABL and Zesty Nimble). Fans angles have been studied with CFD simulations in order to maximize air flow and heat sink cooling. It uses E3D-v5 heat sink from Anycubic original kit (it is an E3D-v5 clone) and 3x 30x30mm fans; 9x M3 nuts; 2x M3 screws; 12x 5mm (diam) X 5mm (height) cylindrical magnets; other components are from Anycubic kit. This effector works better than original Anycubic one since air flow is better oriented toward heat sink and then to nozzle, all around. Consequently 3D printed surface is smoother because of better air flow all around it is far away difficult to clog the throat, heat sink is better cooled down Using magnets to join upper part (corpo) to lower part (diffusore) simplifies dismantling for maintenance; furthermore, it is safer in case nozzle kicks bed glass. On the other hand it is difficult to 3D print PET-G and any other material needing low air flow (or even no fan).
Statistics
Likes
7
Downloads
0