vacuum cleaner crevice tool for Hoover Air Wind tunnel and maybe others
Description
My crevice tool got broken so I ordered a replacement and it wasn't quite the same. It would not sit properly in the holder on the back of the vacuum and fell out all the time. So I made a new one. I added extra fins on the bottom for stability. Just break them off after you print it. I made this easily 2 years ago and it held up fine. PLA but im sure you can use whatever you want. Maybe don't print super fast if you have a moving bed because it prints best straight up and down, thats why I added the support fins. I didn't want to use any other slicer added support.
Statistics
Likes
2
Downloads
0