BSG Viper Replacement Jet Engine Storage
Description
Update 12/15/18 I fixed the top and bottom pieces so they come together closer to the center of the jet engine... If you are planning to make the Viper Launch Tube... https://www.thingiverse.com/thing:3229636 You can stack up some spare Jet Engines for later use. The stack separates. I'm using PLA strands to line up the stacks up to 3 high. OSHA won't allow any higher ;) Will post a pic of final make. These were designed at 1/32 scale. I printed the Jet in 4 colors. Orange for the end cap (1 - 34) Black for the nacelle (35 - 134) Gray for the body (135 - 503) and blue for the tip. Those layer numbers were determined using Cura and a .15mm layer height
Statistics
Likes
40
Downloads
0