I3 Mega Mboard Noctua Mount 1.0
Description
Hey folks I made A Noctua mount for the Mega motherboard. Its a 'very' tight fit but it works. Used sketchup and Cura. You need 1x 92mm Noctua 4x Rubber pins 2x M3 20mm~ 2x Nuts I simply transfered the original fan connector to the new unit. Also Integrated one Noctua low noise adaptor into the cable.. (optional) 1. Move around the board cables thats in the middle, just a bit. Check picture. 2. Merge fan to mount and cut the rubber ends away. 3. Then connect the fan to board socket. 4. Now bolt it to the frame, but before you tighten. Slightly twist the fan left of the connector. As much as possible. Check arrow. Make sure the bottom plate is rotated so the opening is where the fan sits. Done! Did a surgery on the power supply aswell but that was just metal work.
Statistics
Likes
56
Downloads
0