mount - sannceWIFICAM _ anycubic i3 Z axis
Description
An Anycubic i3 Mega-specific mount for the Sancce I41CB 1080P IP camera. https://www.sanncestore.com/ip-camera/sannce-i41cb-1080p-smart-wireless-pt-security-camera.html It's kind of dumb, and sideways, but it works ok and isn't being shoved around my desk. Take care of your cabling out the bottom of the cam, and make sure there are clearances under it. Normally there should be. Even with my gumby Z-endstops there is, so your should be ok. Edit: images that show correct sequence for shims. Doh. - Notes: - 2x button head M3x6mm bolts, and square nuts. Length of these is critical (longer=bad) or they will scrape against your frame. - 2x button or cap head M4x20mm and square nuts - The shims: use them both. - There is a single layer blocking the bolt holes in some part(s). It negates the need to use supports. Shove a drill bit through that. - Assemble the cameras wall mount cup onot the main printed part first, make sure the bolts/nuts do not protrude and are flush or recessed into the rear surface. - Tape the M4 nuts into the nut receiving part, and hold it inside the left X carriage box with your finger, and pin the rest of the pre-assembled parts onto the front with your thumb/other fingers. Screwdriver the M4's with the other hand. Much easier than it sounds. - Works for me: - PLA, 0.4mm nozzle, 0.2mm layers, 0.8mm walls, 20% triangular infill, NO SUPPORTS.
Statistics
Likes
14
Downloads
0