simple and tiny blowgun tail for cold steel darts (.40 cal)
Description
Hi everyone! This is my simple and tiny design of a tail to make your blowgun darts spin as hell. The spinning motion, given by this simple device, makes the dart a lot more stable in flight, increasing precision. The slightly increased inertia due to the little mass of this print makes your shoots even more penetrating and powerful, if compared to standard darts. (you can see a couple of comparison shots in the pics) *no toilet paper was hurt in the make of this project* I strongly recommend to print this tiny piece activating the "spiralize outer contour" option on cura, to get a good quality print despite the strict dimensions (the print is ready in like 2 minutes with a 0.1 layer thickness). Enjoy! EnginEli
Statistics
Likes
38
Downloads
0