HHGTTG Don't Panic
Description
Originally made this as an ornament to go on the extruder of my Monoprice Select Mini. It uses the base from this: https://www.thingiverse.com/thing:1958219 I liked it enough that I made a stand for it to just sit on its own. The parts snap together but you may need some superglue, especially for the teeth and to make the front and back stay together. Most of the parts don't need supports, but the tongue definitely does. The "mouth" part slides into place, holding in the tongue part and making the mouth look black (if it's printed in black) Then the Teeth goes into the groove in the upper lip. You may need superglue to make it stay. Then the back and front line up so the peg will fit into the stand (or the base if you want to use it as an extruder ornament). Superglue can also be used here to hold the back and front together. **Note** that you can use either DontPanic-Stand.stl or DontPanic-Base.stl (if you want to use it as an extruder ornament) but you don't need both. **UDATE** Added DontPanic-Hanging-Front.stl and DontPanic-Hanging-Back.stl where I removed the tab at the bottom and added a loop at the top so the ornament can be hung from a string (no base or stand required).
Statistics
Likes
193
Downloads
0