Anycubic I3 Mega Hotend Cover V3 (7530 radial fan)
Description
Now my [Anycubic I3 Mega Hotend Cover](https://www.thingiverse.com/thing:3224780) (V1) was in use for almost a month. However, it has been shown that the amount of cooling air was not quite sufficient, if overhangs were to be printed on small areas per level. Then I designed the [V2](https://www.thingiverse.com/thing:3234293) - but the new fan didn't want to harmonize with the printer electronics. Therefore now the V3, with which no fan, but a blower is used. This part blows enough air even if it runs at 50%. Fans used: - 1x Noctua NF-A4x10 FLX 40mm - 1x Titan TFD-B7530M12C BOM: - 1x screw M4x40 + nut - 4x M3x30 + nut - 2x M3x16 + washer + nut - 2x M3x16 + nut - 2x M3x10 + nut - 1x rubber band
Statistics
Likes
56
Downloads
0