CR-10S Keenovo heater beefier stress/strain relief with zip loops
Description
****2019 update! after over a years use i decided to add a tab on the top piece which works really well!**** so basically here i had the original and it worked great for a long time, it recently broke but i was looking for the right time to design and print something new for it and here it is! i added brackets for zip ties on the side to secure the bracket to the bed better, they dont have to be removed to take the bed off just slide the glass in and out from under it. i also added a top cover which is just the bracket part flipped and enlarged. strap it down with some zip ties and you're golden. !!!!!! i put this zip tie on and left it there for the picture! do not use the printer with the zip tie on the like this!!!!!!!! Make sure to put the top zip tie on so the clasp is at the side or bottom, as i found out with this test run print, while using a BLtouch and running the pre print mesh leveling test, the hot end/carriage will hit the clasp causing a slight issue miss reading. (circled in red in a picture so you know which ip tie im talking about... alternatively you could use some nuts and bolts perhaps instead of the zip ties in this spot.
Statistics
Likes
7
Downloads
0