PanelDue 5i enclosure
Description
This is an angled case for a PanelDue 5i purchased fall 2018 . It can be mounted on a Ultimaker2 or clone. The microSDcard on the lower left is accessable by a nice rounded cutout. The panel is fixed with ø3x10mm plastic selftaping screws(source https://www.wegertseder.com/ArticleDetails.aspx?AKNUM=3662#nav). Taping M3 might also work. The whole case is attached to the printer body by 2 of these screws and 2 new holes in the front. Using double sided tape to avoid holes may work as gravity is catched by the step in the back. Added on request: Version for 4.3" panel (untested, as I do not have this panel)
Statistics
Likes
20
Downloads
0