holder for hair dryer (glueable+fast print)
Description
Definition: Wall mounted holder for a hair dryer. Can be glued in place List of Parts / Dimensions: 1x Holder: 10,5 x 10,5 x 3,2 cm, hole: 9,5 cm in diameter 6,5h printing time, 18m PLA, 51g 1x strip of double-sided tape or 2x screws with 2 x dowels (Scaling down is no problem. Scaling up is possible, but could affect the stability of the object.) Hints: Glueing requires clean, flat surfaces. I suggest you clean the areas with alcohol, swipe everything off and let it dry for a minute. Sanding the holder back side will also increase the stability of the connection. If done correctly, the holder should withstand aproximately 1,5 kg of weight permanently. Screwing the holder in place should result in a much stronger connection though. Choose suiting connections for your wall surfaces (don't glue on wallpaper). The infill shouldn't be thinned out too much, or the structure will break. I advise a wall thickness of 3 mm, top and bottom thickness of 1mm and an infill of more than 33%. Always prefer a thicker skin than more infill for the best stability! Disclaimer: I do not accept liability for damage resulting from usage, installation or manufacturing of my product.
Statistics
Likes
13
Downloads
0