Filament Guide and Mount for Sunhokey filament sensor
Description
This is a mount I designed for use with my Railcore II 300-ZL and the sunhokey filament out sensor. The 3rd pic shows where the sensor gets plugged in, and the order of the wires in the plug you have to attach is White - Red - Black from left to right. Update 4/27/20: If using Duet2 add: M591 D0 P1 C3 S1 ; enabled filament out sensor to the end of your config.g to enable the sensor. You will also most likely have to re-pin the connector. Just new a small (as in tiny) flat screwdriver to compress the pins enough to remove them and put them in the correct order. https://www.amazon.com/dp/B07JJ2835X/ref=cm_sw_r_cp_api_i_z6CeCb3G27RHV?fbclid=IwAR2_Us0-jaAHoZfGpuYgfTUWQ0pwspDxJYOePmkfyseI-OVl9pPluVbl__4
Statistics
Likes
15
Downloads
0