GPU-holder
Description
Hello, After I found out that the EVGA 1080Ti-FTW3 card doesen't fit the Louqe Ghost case then I started to tinker with Inventor to see if there was a solution so that I could use my expensive GPU in the new case. This holder should work for all types of GPU's (I think). This bracket/holder will lower the GPU/riser-cable 10mm from its original position, making it possible to use the GPU with the standard cables for my Corsair SF600v2 PSU. Harder or more rigid cables could still cause a problem, but with a low profile connector this should not be a problem! This also means that the LED-stripe no longer needs to be removed from the top of the card. note: When you lower the riser cable it also means that you need to straighten the cable, and re-bend it at a new position! Check this up!: In another slicer software it seemed that the scaling was off. The height of the whole piece should be 11.7mm! (Edit: only for v1) Version 2: Added some material on the top of the right side from a request. I haven't printed and tested it yet but it might be problems to fit it. Please comment if it does/does not. also this versions seems fine in the scaling. Version 3 (2019-07-10): Added slightly larger holes for fit in the ghost. Screw holes the same size. Added a slightly modified structure to the right holder, so it can fit the GPU/riser fastener better then v2. I would consider this the final version.
Statistics
Likes
23
Downloads
0