Stag. Deer with antlers

Stag. Deer with antlers

Description

I received a birthday card that had a laser cut stag on it. I thought it was pretty neat so I took a photo and created several printable versions. One has the antlers separate with dovetail joints to connect them This is for smaller printers or if you want to go large with it. The second is an all in one version which you can print at the size you want that will fit your printer. For the one with the antlers as separate pieces I made them have 0.25 mm clearance on the dovetails and also angled the sides of the dovetails and the holes at 6 degrees. I have not tested them yet but they should fit tight or you may need some glue. No support is needed on the one piece. The 3 piece version will need support under the dovetail cutouts.

Statistics

Likes

53

Downloads

0

Category

Sculptures