AM8 12V 30a 360W Power Supply Switch Cover
Description
The original by Haabilo was a good cover however the amount of material used was quite high, it didn't fit well with how I wanted to mount my PSU and it lacked access to any internals. All other power supply covers I found also have very similar issues so found my favourite and adjusted to my needs. This remix has over a 50% reduction in material use, provides full access to the internal wiring through the holes to add/remove items without having to fully unbolt and has options at the bottom to route cables, there is a tight gap by the corner brackets where power cables and the z motor cable could route. There's a cutout at the bottom for further cable routing/cable management and there's a small hole on the left hand side to route the z motor cables through if wanted. I mounted my PSU in conjunction with the following PSU mount: https://www.thingiverse.com/thing:2333229 The bottom bracket needed a quick melting spell with a lighter to fit snuggly against the bolt used to attach it to the PSU but works quite well.
Statistics
Likes
15
Downloads
0