Duet Wifi configuration for TronXY X5S
Description
READ CAREFULLY! This is MY configuration for the TronXY X5S for the Duet Wifi controller board. Because it's MY configuration i can not gurantee it will work with yours. 1. Before uploading the files check the config if it matches your setup!!! 2. You have to add YOUR wifi name and password to the config.g 4. First check your machine before start a print!! Maybe my maximum position is more than yours so if you not check your machine will maybe destroy something My setup: (Capital written words = potentially problem area, you may have to adjust in config) TronXY X5SA (same as X5S but stock with other controller board and some addons) BLTOUCH AUTOLEVEL SENSOR Bondtech extruder with PENCAKE STEPPER (More steps than stock) SINGEL Z DRIVE (More steps than stock) Filament run out sensor (should be no problem if you don't connect one) Some more hardware things which should not be problematic For wiring the duet you should take a look into the documentation: https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams For wirirng the bltouch take a look at: https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe Also take a look at my mods for the X5S: https://www.thingiverse.com/thing:3206802 https://www.thingiverse.com/thing:3206767 https://www.thingiverse.com/thing:3206779 If you have some helpful tips or website please share them with the others. Thank you for donations
Statistics
Likes
41
Downloads
0