CR-10S Chain Cable Adapter
Description
This is a modified version of the original cable chain for the Y axis. I"m not the creator of the original one. I used this Cable Chain setup and only modified the part that connects to the bed to keep that part as factory setup. https://www.thingiverse.com/thing:2798484 The previous version was designed to replace the original entire support from the bed throughout the cable. The version I modified is a piggyback version. The new CR10s already comes with a re-inforced system for the cable on the bed and I did not want to replace it. I just wanted to add the cable chain and that is why I modified it so I do not have to remove factory setting. Just insert this one into factory connector in the back and add 2 zip-ties. You do not need to remove the original support that came with your CR-10S. NOTE: I am using cable extensions with my CR-10s. Just using the ones that came with your printer will be too short in my opinion to use. Hope this helps you out.
Statistics
Likes
9
Downloads
0